What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 05:23

First Sentence:
A circuit breaker is similar, but is resettable.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
AMD once again first to top GPU clock charts with RX 9060 XT delivering 3.1 GHz - VideoCardz.com
what exactly is a ‘surge’ protector?
This device then solves the entire problem.
There are three different concepts here that are getting confused.
Investigative Reporters Sound the Alarm at Peabody Awards - Variety
He then describes Rainy Season and Lightning.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is the scope of generative AI?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–10[John johnson John Johnson ]
What’s a historical event you wish more people talked about?
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
At least they know the answer if they wanted it.
Relativistic jet detected in active galaxy Markarian 110 - Phys.org
so, what happens?
Barnstars:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
AL East Notes: Bigge, Kim, Scherzer, Westburg, Gil, Williams, Weaver - MLB Trade Rumors
What is lightning?
Now when you have a certain ac resistance, then a current flows in a loop.
Because the load is inductive, the current lags the voltage.(by a bit).
Beyoncé Briefly Dangles Over Houston Stadium Crowd As Flying Prop Car Malfunctions - Deadline
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
In schematic diagrams this is the symbol for a fuse:
The other is “what does a “fuse” do?”
2024–10–14 [Omar Gharbi Omar Gharbi ]
He then asserts :
Biotech pauses trial after second patient death linked to gene therapy - The Washington Post
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
What does a fuse do?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but this device (an Inductor) … impedes the rapid changes in the current.
the problem then depends on "how fast does the fuse operate?".
A fuse is a non-resetable over current circuit protector.
Royals share new photos of Prince William with children - BBC
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
What is so great about Jiraiya?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There are two important concepts here.
He then describes the function of a fuse.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
I post the exact comment here.
Here is a simplified AC power diagram.
An AC voltage/ current source, and an ac inductive load.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is 'the assistant's answer'
One is “what exactly is in a ‘surge protector’ ? ”
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
For this case there are devices called Metal oxide varistors (MOV).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
but I think this circuit , shows a few more pieces.
Edit 2024–10.
But it can get overloaded, and no longer works.
Upvotes:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
One
It also is a device that limits the change in current flow.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
[old diagram got deleted by accident]
This is where this question deviates from being a 'generic' question, and becomes more specific.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
a photo is worth a thousand words.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It seems Mohan does not understand the difference between a comment and an Answer.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
nine
At one ohm, the resistor has a maximum of 1 watt power.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The third is lightning and “how it gets conducted into a home.”
These devices are installed between the “hot” and “neutral” and protective ground.
But… the neutral is now “floating” because of the 1 ohm resistance.
The bolt then partially travels down the line to your home.
These are simplified answers to the original question, and does not change anything I wrote above.